CIBSE approved CPD - An introduction to MLCP

BESA and CIBSE

 

Enrol on our CIBSE approved CPD, An introduction to multi-layered composite pipe, today!

During this 45-minute course, participants will learn about the benefits, history, standards, applications, material composition and installation of MLCP.

The course is conducted by a Product Specialist at a location of their choosing or via Microsoft Teams.

The CPD will soon be available on the BESA Academy

Free Aquatechnik Installation Training - Installer Competences Checklist

Aquatechnik offer free product installer training via our UK distribution partner Smith Brothers Stores.

The training is conducted by a Regional Product Specialist, who is on hand to provide complete technical support to customers, with training at a location of your choosing or via Microsoft Teams.

Upon completion of the course, participants will receive a certificate, an ID card (with lanyard) confirming they have undertaken the training, which can be carried and displayed whilst on site.

Successful completion of the course will also activate a 25-Year Aquatechnik warranty.

  1. Ensure that the fittings remain in the original packaging, or the SBS-supplied delivery packaging, right up to the point of installation to prevent the WRAS approved seals from being contaminated.

 

  1. Cut the Multilayer pipe, preferably with sharp hand shears or a wheel-type tube cutter that produce no debris, keeps the tube end square, and produces minimal tube end burrs.

 

  1. Unbag the MLCP fitting and remove the fitting cap-nut.

 

  1. Insert the cut tube through the cap nut (This cannot be done after flaring)

 

  1. Hold the cut tube-end firmly onto the correct size of flaring head and pull the machine trigger until the flaring process is complete.

 

  1. Push the flared tube end onto the MLCP fitting and tighten the cap nut by hand until it clicks onto the locking mechanism. Special MLCP wrench available for all sizes should hand tightening not be possible.

 

  1. Test the system following the BESA TR6 ‘Guide to Best Practice’ for Site Pressure Testing of Pipework.

Flaring Machine Maintenance – Aquatechnik BST32

  1. Ensure the flaring-head expanding-elastomers are kept free from external grease so they can grip the tube wall during flaring.

 

  1. Heat up the elastomers in hot water, to improve their elasticity, if they have become cold overnight or not used for a long time.

 

Aquatechnik/Rothenberger BBR90

  1. Ensure the flaring-head expanding-elastomers are kept free from external grease so they can grip the tube wall during flaring.

 

  1. Ensure that the expander-head Conical-Pin is regularly lubricated with 50825 graphite grease.
Safety Plus tool

Aquatechnik UK

A multi-layer WRAS approved system up to 75mm with patented fittings which have excellent flow characteristics, reducing the pressure required to achieve the required flow rate, often with reduced noise pollution over other pipe technologies.

Facebook-f Linkedin-in Instagram

© 2023 Registered Office: Unit V2 Winchester Avenue, Blaby, Leicester, LE8 4GZ | A member of Aquatechnik UK